Steveo_supremo
ArboristSite Guru
My 026 has a baffle inside the air filter that looks to be quite restrictive. It comes out of the air filter easily. Has anyone removed thiers, did it make a difference? Any drawbacks to removing it?
Last edited:
026 Baffle in the air filter
- Thread starter Steveo_supremo
- Start date
Help Support Arborist Forum:
PWB
ArboristSite Guru
Are you talking about the choke? There's no choke in the carb on an 026, it's in the filter and is activated by the lever if everything is put together right.
Work Saw Collector
GTG Coffee Maker
The saw would be hard starting without it, but might breath better.
MS460WOODCHUCK
Addicted to ArboristSite
You remove it every time you shut the choke off.
Sorry man I had to!
Sorry man I had to!
Steveo_supremo
ArboristSite Guru
No, I'm not talking about the choke. It is a plastic baffle that sits inside the outer half of the filter behind the choke flapper.
Steveo_supremo
ArboristSite Guru
Anyone?
Bill.A.Bong
ArboristSite Member
Is part #8 what you are talking about - seems this baffle came in some styles of 026 airfilters - but not mine......
2000ssm6
Stihl User
Yup, ya'll have different versions of the 026 filters.
I don't see where it would hurt anything taking it out but I doubt any power will be gained. If you do remove it just be sure it doesn't serve as the choke shaft's support or a structural brace for the air filter to seal against the carb housing.
I don't see where it would hurt anything taking it out but I doubt any power will be gained. If you do remove it just be sure it doesn't serve as the choke shaft's support or a structural brace for the air filter to seal against the carb housing.
I remember seeing that thing on an old 026 filter. I bet it is integral to the structural integrity of the filter, but I bet it could be modified to allow more air through.
Steveo_supremo
ArboristSite Guru
Yes, it is part number 8. It looks like with the baffle in it has to draw most of the air from the "front" side of the filter (the side towards the engine). With it out, it should get equal amounts of air from the front and back of the filter.
My 026`s don`t have that baffle in the airfilter so you could take it out and try it that way, if it works good with no problems after cutting with it for a tank or two then just leave it out. I don`t think the 026 has enough suction to collapse the airfilter housing upon itself.
Pioneerguy600
Pioneerguy600
