I'm piecing together a saw from a rental company. I'm hoping to get a little help from someone who has been around these. It cut well, but did not stall the chain at idle. When I disassembled the clutch the shoes were stuck out to the drum. When I loosten the center hub the shoes retract all by themselves. New shoes, springs, and guides were already installed. I think it's binding against the washer behind the assembly. When I look at the IPD it shows 2 size washers available. The retainers I have don't match the picture exactly. They have short supports for the springs that are not in the picture. Finally, when I tighten the hub down, the shoes push out a little bit. Maybe .010.
So what do you think?
Thanks,
Couper
So what do you think?
Thanks,
Couper