NZBOBK
New Member
Righto, upon reinstalling the oil pump clutch etc I noticed in the service book under "servicing the oil pump" section that there is a "O" ring shown installed under the spacer bush. Now when I assembled the saw using the previous sections of the book, it shows the spacer being installed without an o-ring. As my saw was already in bits whan I got my hands on it, I have no idea which is correct: Refer page 76 on the manual as well as 41 and 46 to see what I mean. Also what threw me is that there is no o-ring pictured in the IPB either (page 6, oil pump) My gut tells me that It should be there to seal between the bush, bearing inner race and the crank.
Can I please have an answer on this.
Ps I have just installed a Baileys BB cylinder and piston and are not sure If I should be able to turn the thing over by hand on the flywheel, seems real low on comp compared to my 041FB.
Cheers
Thanks all
What a fantastic site this is.
Can I please have an answer on this.
Ps I have just installed a Baileys BB cylinder and piston and are not sure If I should be able to turn the thing over by hand on the flywheel, seems real low on comp compared to my 041FB.
Cheers
Thanks all
What a fantastic site this is.