066 Carb Adjustments

[Cuein]

I'm confused...and I realize it's likely just me... In the instructions for the 066 it says for the "H" screw. Turn high speed (H) Counterclockwise up to the stop," If I turn it all the way clockwise, it stops, but turning counter clockwise as it says, it never stops, it just unscrews out of the carb body. Am I reading that wrong. Do I turn both the L and H all the way to the stop, then back H off 3/4 and L off 1/4? See below grab from the 066 manual.

 

[Marine-piper]

I believe it's a typo on the H because the L is correct. Clockwise to seat then back to setting. Unless the H has a lefthand thread!

Homelite collector in training [emoji879]

 

[Cuein]

I believe it's a typo on the H because the L is correct. Clockwise to seat then back to setting. Unless the H has a lefthand thread!

Homelite collector in training [emoji879]

Both are stardard righty tighty...So, you think I should just go full clockwise to start, then back off as recommended? Thanks!

 

[Marine-piper]

Yes, lightly tighten to seat and counterclockwise to set.

Homelite collector in training [emoji879]