2055 Carb ?s

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Bootsie

ArboristSite Operative
Joined
Jan 25, 2009
Messages
344
Reaction score
31
Location
Nova Scotia
So I replaced the tank vent line and the one way valve. I gave it a splash of fuel choked it, a couple pulls and it roared to life. I had the carb set at 1.5 turns each. Once it was warm I let it down to idle and everything was fine. Once I went to rev it up again it bogged and died. I fired it back up and tried again but this time feathering the throttle and everything was fine. So my ? is do I need to adjust my L screw down a bit? Thank guys. Oh, you guys were not lying this thing is a screamer. To bad it is a flip saw.
 
Open it up a liitle more on the low side, if you get out beyond 2.5 turns its time to look for another problem.
 
Cold natured.I believe mine is at about 2 turns on the high side.
After it warms up adjust till it 4 strokes.
Yes it is a screamer, even more when it's ported with the muffler opened up.Sounds sweet too.
 
Back
Top