Hey Everyone,
I'm just picked up a 254XP and I'm looking to do some modifications. I'm not too sure how far I would like to take it at this point but I will for sure be doing a muffler mod and some cylinder port work. I am also considering taking some material off the cylinder base (I would like to run a gasket).
I'm not sure if this particular saw could benefit from an ignition timing advance.
Larger carburetor?
I am already taking apart the case to replace bearings and seals.
Looking to hear some thoughts on what is worth doing and what is not worth doing.
I'm just picked up a 254XP and I'm looking to do some modifications. I'm not too sure how far I would like to take it at this point but I will for sure be doing a muffler mod and some cylinder port work. I am also considering taking some material off the cylinder base (I would like to run a gasket).
I'm not sure if this particular saw could benefit from an ignition timing advance.
Larger carburetor?
I am already taking apart the case to replace bearings and seals.
Looking to hear some thoughts on what is worth doing and what is not worth doing.