D
Deleted member 117362
Guest
2012 372x-torq rebuild, pictures should tell the story. You will see two clutch covers, a complete nice gray one and one orange with a chip on lower back end (you pick). Two air filters covers, one has a small crack and other is dull in color (you pick). Saw is not pretty and shows scratches on covers and fuel tank. That being said the guts of this saw are in very nice condition, as pictures show. New Caber rings, new AM chain plate, new SKF case bearings, new seals, new gaskets, new NGK plug, new starter rope, new oem brake handle, new oem o-ring and whatever else was need to make it complete and ready to cut. One picture shows a 7 pin or 8 pin drive gear (you pick), also comes cylinder decompression plug and top case plug. Muffler was opened up under screen. Case was vacuum checked and holds a steady 7 lbs. Coil is unlimited and I only showed tach idle, to show it runs. Piss reved twice to set high down to 12,800 and you can turn it up as you like. Motoseal was sealant used and blue thread locker on case, cylinder, muffler, front inner spike, oil pump and coil bolts. Questions? Just ask, this will be my last build and may list some parts I have built up at later date. $400.00 Paypay F&F or Postal Money Order is fine, plus shipping. Will try to list all pictures from start of build to finish.
