Yotaismygame
Juiced Saws #GetJuiced
I’m working on a saw right now that does not have locator pins. Crazy!? Yes! I would like to do more work to the exhaust port like remove the ring support that goes right through the middle of the port. But I’m worried with there being no way of holding the rings in one spot if the ring end found its way into this bigger exhaust port it’ll snag.
This saw uses two thin rings. I could either use just the top ring and place a pin in the middle of the intake or use both and place them between the exhaust and transfers.
I’ll bring @drf255 into this because I’ve seen him talk about re-locating pins.
Thanks
This saw uses two thin rings. I could either use just the top ring and place a pin in the middle of the intake or use both and place them between the exhaust and transfers.
I’ll bring @drf255 into this because I’ve seen him talk about re-locating pins.
Thanks