magbarn
ArboristSite Lurker
What should the NE346XP be tached at? I assume it's different from the original 346xp?
advice on 346 xp e tech
- Thread starter 441_Stihl
- Start date
Help Support Arborist Forum:
drmiller100
ArboristSite Guru
remove bar.
remove top cover.
remove lower bracket, which requires removal of one dog screw.
remove 2 tube screws.
remove muffler, gasket, heat shield.
replace in reverse order.
remove top cover.
remove lower bracket, which requires removal of one dog screw.
remove 2 tube screws.
remove muffler, gasket, heat shield.
replace in reverse order.
SawTroll
Information Collector
The few statements I have seen tend to conclude that they do their best when set at slightly less than 14K - mine is still set a bit lower for run-in.....
Last edited:
magbarn
ArboristSite Lurker
I've been keeping mine around 12750 for break in, it's running quite rich though and might raise the revs to 13250 or so.
SawTroll
Information Collector
That is a bit too conservative, imo.......
THALL10326
The Champ
Exactly. I see no gain in cut times or power when tached over 14 grand. Mine cuts just as good at 13,500-13,800 as it does hitting 14-14,300. I think the max is 14,500 but why scream it that high for little or no gain in power.
Your on the money Troll..
SawTroll
Information Collector
Really nice to see you post again!!!!
:yourock:
Btw, they are rev limited at 14,2K, and recommended max is 14,1, vs 14,7 for the 45cc version.
Last edited:
Yes. It falls in between Stihl chain and Oregon.
