SteveSr
Addicted to ArboristSite
Several actually... Now if I could find a source for the cap gasket I'll be set!Are you trying to fix a trimmer gas cap?
Several actually... Now if I could find a source for the cap gasket I'll be set!Are you trying to fix a trimmer gas cap?
It's good but too expensive. I work as a volunteer for a local non-profit trail club with limited resources. Just about every trimmer has a leaky cap by the time I get it to rebuild. Why spend $20 on a new cap when a duckbill is $1.25 (Walbro price if it is the correct one)?The newer version cap is no good?
I am not a fan of aftermarket parts especially ones with rubber parts in contact with fuel of fuel vapors.I think it is even available aftermarket.
Stihl price list:
4128 350 0505 FUEL FILLER CAP 9.99
So if you order one of these, and it is not "correct". Will you send it back, contest the transaction, and screw the seller?Well, here is what I have been able to dig up from the most likely Walbro candidates:
Walbro 176-64-1 - AKA Stihl 4133-121-5200:
Size: 10mm O.D. 3mm install hole
Material: Orange Fluorosilicone
Cost $1.40 Walbro MSRP
Primary Applications: Carburetor purge valve (under the bulb)
Walbro 176-126-1 :
Size: 10mm O.D. 3mm install hole
Material: Black Fluoropolymer AKA Viton
Cost $1.24 Walbro MSRP
Primary Applications: Fuel system vents in caps & tanks.
Stihl - 4114-353-1600:
Applications: Some saw tanks vents (026) and Early FSxx AV brushcutters tank cap vent.
Enter your email address to join: