ANOTHER bearing question

[DougMN]

Run a 3/8" long bead with a mig welder on the inner surface of that outer race, it will fall right out.

BINGO

 

[glock37]

Heat case up around bearing race opposite side then take a punch or screw driver on the inner race thru seal hole place blade on race where balls ride tap it race should come out real easy


Sent from my iPhone using Tapatalk

 

[Sylvan21]

You need to run the a hot pass with a welder like pioneer said done it on on big rig hubs works awesome

 

[ErikS]

TAADAA!! :-D

Thanks guys.

 

[Marshy]

Run a 3/8" long bead with a mig welder on the inner surface of that outer race, it will fall right out.

This ^ is the answerr.

 

[ErikS]

I used Brad's method. Reassemble bearing (I used 4 of the roller balls spaced evenly apart), heated the case, knocked it right out. No problems. Now, off to Glock37 for powdercoating

 

[blsnelling]

Good to here you got it resolved. I'll have to put the welding trick in my back pocket!

 

[ErikS]

Im with ya on that welding one. Never would have thought of it!

 

[glock37]

I dont think i like the idea of welding in the race one slip and possible hole in case

If you he the case enough u can install a bearing with one finger taking one out should be just as easy get case hot and tap the whole case on table it may fall out or tap it out as a said before Just my thoughts


Sent from my iPhone using Tapatalk