jackjcc
Addicted to ArboristSite
Guys I’m out ideas on this 029...
The saw starts on 3rd or 4th pull. It runs for 5 minutes and then struggle and dies. It used to basically die out in the cut and would not restart unless it was cooled off, so I swapped out the coil with an untested used one, same issue. Now I’ve swapped out the entire electrical system from an ms290 flywheel included. It ran for a bit longer today and I got through some 5” test cuts when it started bogging out again, it sounded like when you have the choke after it’s warm, starts to die off. The real difference here is that it restarted on one or two pulls.
So I thought maybe the tank vent but after opening the gas cap it was still bogging after starting and would die out.
I’m gunning plug the fuel line in and vac test it. Please post up some ideas fellas...I’m about ready to tomahawk this saw across the driveway.
Sent from my iPhone using Tapatalk
The saw starts on 3rd or 4th pull. It runs for 5 minutes and then struggle and dies. It used to basically die out in the cut and would not restart unless it was cooled off, so I swapped out the coil with an untested used one, same issue. Now I’ve swapped out the entire electrical system from an ms290 flywheel included. It ran for a bit longer today and I got through some 5” test cuts when it started bogging out again, it sounded like when you have the choke after it’s warm, starts to die off. The real difference here is that it restarted on one or two pulls.
So I thought maybe the tank vent but after opening the gas cap it was still bogging after starting and would die out.
I’m gunning plug the fuel line in and vac test it. Please post up some ideas fellas...I’m about ready to tomahawk this saw across the driveway.
Sent from my iPhone using Tapatalk