Best bar for milling

[newbliss]

Sorry if this is something recently posted on, I couldn't find it by searching. I need to buy a new bar for my Logosol CSM. I'm running an 066 and am looking for a 20-24 inch bar. I hear the GB bars are good, but I don't know where to buy them. What other brands/models have people had good experiences with, that will hold up for a while. I'll be using low profile rip chain from Baileys.
Thanks

 

[dustytools]

Go to jackssmallengines.com they carry GB bars.

 

[newbliss]

Thanks so much. I've dealt with them before.

 

[oldsaw]

Okay, now that is settled, what bar do we go to after milling?
Had an "Irish Pub" open up a couple of blocks from work. No food (boo!), but they had Smithwick Ale on tap (kind of makes up for it), now I just need time to stop in every now and then.

I've got my first GB bar to play with, but have been milling with an Oregon PowerMatch and been impressed so far. Holding up very well, much better than the older 36" Oregon I have. Whooda thunk it?

Mark