lambs
Stihl crazy after all these years
I used a protractor and indexed my 511a to read accurately
Me too. You can put a DAF up against the side of the grinding wheel to see if it's at the angle shown by the grinder index.
I used a protractor and indexed my 511a to read accurately
How did it cut?I think this was 30 on the wheel tilt ,-30 on the base slide ,and 20 or 25 on the top plate angle ,came out looking almost like square
View attachment 387701 View attachment 387702 View attachment 387703 View attachment 387704 View attachment 387705
Because its semi skipEven round filing, I get better results than off the roll
And why do you think that was ?
Both resharpened chains were ground on the USG at the same angles
good looking chain. I will try that on my usg!I think this was 30 on the wheel tilt ,-30 on the base slide ,and 20 or 25 on the top plate angle ,came out looking almost like square
View attachment 387701 View attachment 387702 View attachment 387703 View attachment 387704 View attachment 387705
Enter your email address to join: