troutfisher
Addicted to ArboristSite
Can anyone tell me the Displacement of the Bailey's big bore kits? I found the bore diameter (54mm, 56mm, ect.) But I need to know the CC's for the 046's and 372's.
Big Bore Cylinder Displacement
- Thread starter troutfisher
- Start date
Help Support Arborist Forum:
troutfisher
Addicted to ArboristSite
Bump...........Nobody knows what the new displacement is after installing these kits?
pi times radius times radius times stroke.
Cameljoe73
ArboristSite Operative
+1
Erick
Addicted to ArboristSite
044/440 Big Bore = 76.5cc
046/460 Big Bore = 82.4cc
066/660 Big Bore = 98.8cc
372 Big Bore = 76.5cc
046/460 Big Bore = 82.4cc
066/660 Big Bore = 98.8cc
372 Big Bore = 76.5cc
Erick
Addicted to ArboristSite
Yep that's the way I read it to.
sleeper..................
sawinredneck
Addicted to ArboristSite
troutfisher
Addicted to ArboristSite
Thank you. I wanted to know if they would fit into a 0-80cc class
Last edited:
Nope, if done right, it's bad azz
'zacly what I said!!!!!!!!
Erick
Addicted to ArboristSite
A sleeper is like a Q ship. Looks sleepy stock, kicks butt. Like a '79 Caddy Seville with a twin turbo Rat motor. It did 185, looks dead stock.
RiverRat2
Serio Tree Freak
Lolol!!!!
Ive got a MS 440 w/woodsportedBB Kit...... we use it for blocking down big trees when the 020T runs out of bar length on the big limbs,,,,,
Run a 28" Oregon Reduced weight bar on it,,,,,
It freaking Rocks!!!!!!!!!!
Ive got a MS 440 w/woodsportedBB Kit...... we use it for blocking down big trees when the 020T runs out of bar length on the big limbs,,,,,
Run a 28" Oregon Reduced weight bar on it,,,,,
It freaking Rocks!!!!!!!!!!
Ive got a MS 440 w/woodsportedBB Kit...... we use it for blocking down big trees when the 020T runs out of bar length on the big limbs,,,,,
Run a 28" Oregon Reduced weight bar on it,,,,,
It freaking Rocks!!!!!!!!!!
Like I said: 'zactly!!
(Why not the 460 BB on your 440?)
As Mae Weast said: Too much if a good thing.........is wonderful!!
Moderation is for monks.
Bowtie
Gearhead
I have asked this a few times. The responses I get are worrying about the bottom end holding up. I aint doing it to my 044, but Im curious to see if anyone does it, Im all ears!
PA Plumber
Addicted to ArboristSite
That Mae West quote is on our fridge.
Re the 460 BB kit on a 440. Wouldn't you need to mount an extra fuel tank on the saw to get any cutting done?
Is seems that thing would go through fuel faster than a rapid chihuahua.
Erick
Addicted to ArboristSite
It does..... but it goes through wood like a rabid Chihuahua on crack.
Whose father was a Pit Bull. Over squares love to rev!
