Den69RS96
ArboristSite Operative
I have a 10kw Briggs portable generator. Last month I started it up and it would only stay at idle. The idle control switch was off. I can manually pull on the throttle linkage and it will rev and stay at operating Rpms. If I set the idle control switch to on it will bring the engine back down to idle when there is no load. It will stay at operating rpm when there is a load on it. Now once it's back at idle it will not rev up if I plug a load into it.
I tested the on/off switch and it's fine. I replaced the idle control board and the idle control transformer. The stepper motor works in both directions so I'm at a loss as to what it could be the issue. Any ideas?
I tested the on/off switch and it's fine. I replaced the idle control board and the idle control transformer. The stepper motor works in both directions so I'm at a loss as to what it could be the issue. Any ideas?