Our Disaster Relef team was donated a MS180C with a Tool-less chain tensioner and a 14", .043 bar.
The saw runs well but the tool-less tensioner is junk.
Want to buy a "DEAD" MS180 with the two-bolt side plate. I think a MS170 side plate will also fit.
Also want to buy a 16", .05 bar for it.
How much would such things cost me???
It will be tomorrow before I can reply.
Thanks
David
The saw runs well but the tool-less tensioner is junk.
Want to buy a "DEAD" MS180 with the two-bolt side plate. I think a MS170 side plate will also fit.
Also want to buy a 16", .05 bar for it.
How much would such things cost me???
It will be tomorrow before I can reply.
Thanks
David