Butch1957
ArboristSite Member
On a 8 hp Briggs Horizontal Shaft ( M-190432 T-6035 ) how would one adjust the governor shaft/lever/set screw for this type of unit ?
Please Respond.
Thanks.
Please Respond.
Thanks.
Governor
- Thread starter Butch1957
- Start date
Help Support Arborist Forum:
cuttinscott
Addicted to ArboristSite
butch,
1) LOOSEN SCREW HOLDING GOV LEVER TO GOV CRANK
2) ROTATE THROTTLE LINKAGE FROM IDLE POS TO WIDE OPEN POSITION. NOTE DIRECTION OF ROTATIONOF THE GOV ARM ATTACHED TO THE THROTTLE LINKAGE
3)PLACE AND HOLD THE LINKAGE IN HIGH SPEED POSITION
4)WHILE HOLDING THE LINKAGE IN THIS POSITION USE A PAIR OF PLIRES TO ROTATE THE GOV SHAFT UNTIL IT STOPS IN THE DIRECTION AS NOTED IN STEP 2
5)TIGHTEN SCREW THAT HOLDS GOV LEVER TO GOV CRANK 35- 45 IN LBS
6)BEFORE STARTING ENGINE MANUALLY ACTUATE GOV LINKAGE TO CHECK FOR BINDING
SCOTT
1) LOOSEN SCREW HOLDING GOV LEVER TO GOV CRANK
2) ROTATE THROTTLE LINKAGE FROM IDLE POS TO WIDE OPEN POSITION. NOTE DIRECTION OF ROTATIONOF THE GOV ARM ATTACHED TO THE THROTTLE LINKAGE
3)PLACE AND HOLD THE LINKAGE IN HIGH SPEED POSITION
4)WHILE HOLDING THE LINKAGE IN THIS POSITION USE A PAIR OF PLIRES TO ROTATE THE GOV SHAFT UNTIL IT STOPS IN THE DIRECTION AS NOTED IN STEP 2
5)TIGHTEN SCREW THAT HOLDS GOV LEVER TO GOV CRANK 35- 45 IN LBS
6)BEFORE STARTING ENGINE MANUALLY ACTUATE GOV LINKAGE TO CHECK FOR BINDING
SCOTT
Similar threads
