Zombiechopper
Addicted to ArboristSite
So.... ALL my other saws have always been ported and modded. By me. Never felt the need to mess with the 200T's because they act like a ported saw out of the box, and because I always had bigger saws ready to go. Now I want to mess with them. What to do....????
Might widen the exhaust a tiny bit, but really the ports look good stock, and it already runs. I'm going no base gasket (or make one to get my squish). What is the opinion on grinding? Does it need it? What would one even do with those open transfers? I could radius the bottoms a bit, and maybe widen a smidge towards the intake. Looking for opinions from anyone who has tried porting one
Advance timing. Never done this before. Shave 1/3 of key= ~5degrees??
Last place I can see room for improvement is inside the muffler. Since it comes apart, it can be 'ported' inside to improve flow. Has anyone tried this before? Waste of time?
Just forming a game plan. Looking for ideas
Might widen the exhaust a tiny bit, but really the ports look good stock, and it already runs. I'm going no base gasket (or make one to get my squish). What is the opinion on grinding? Does it need it? What would one even do with those open transfers? I could radius the bottoms a bit, and maybe widen a smidge towards the intake. Looking for opinions from anyone who has tried porting one
Advance timing. Never done this before. Shave 1/3 of key= ~5degrees??
Last place I can see room for improvement is inside the muffler. Since it comes apart, it can be 'ported' inside to improve flow. Has anyone tried this before? Waste of time?
Just forming a game plan. Looking for ideas