Grande Dog
ArboristSite.com Sponsor
Howdy,
At 7000', (even as lean as they set them from the factory these days) if the locks haven't been taken off, you're not getting it adjusted.
394's were prone to vapor lock because of their solid intake manifold block. The 395's went to the rubber insulated intake manifold and cured the issue.
If your saw stops slowly, suspect the the tank vent. If it stops like the switch was shut off, suspect the module.
Regards
Gregg
At 7000', (even as lean as they set them from the factory these days) if the locks haven't been taken off, you're not getting it adjusted.
394's were prone to vapor lock because of their solid intake manifold block. The 395's went to the rubber insulated intake manifold and cured the issue.
If your saw stops slowly, suspect the the tank vent. If it stops like the switch was shut off, suspect the module.
Regards
Gregg