shorthunter
ArboristSite Guru
I noticed an ebay ad for the second gen, Dolmar 6400 hyway cylinders. 47mm bore but closed port design
Anyone bought one? Did I miss a thread on this?
Anyone bought one? Did I miss a thread on this?
Hyway Cylinders for the Dolmar 6400
- Thread starter shorthunter
- Start date
Help Support Arborist Forum:
shorthunter
ArboristSite Guru
Why not a 52mm jug?
Must be 4 cube racing?
I'd want to see the transfers, even if just from the outside. Does it still look flat like a 6400 or contoured like a 7900?
An under-bored 7900 would be interesting with maybe some extra material to work with and the extra sweep in the transfer loop.
Watch out 365sp...
I don't trust them after the half-assed thing they and Meteor did with the closed port 55,
basically just slapped a horizontal bridge across the straight up open ports without changing much else.
Well, they did add a vertical divider also but... What a waste of possibilities...
Must be 4 cube racing?
I'd want to see the transfers, even if just from the outside. Does it still look flat like a 6400 or contoured like a 7900?
An under-bored 7900 would be interesting with maybe some extra material to work with and the extra sweep in the transfer loop.
Watch out 365sp...
I don't trust them after the half-assed thing they and Meteor did with the closed port 55,
basically just slapped a horizontal bridge across the straight up open ports without changing much else.
Well, they did add a vertical divider also but... What a waste of possibilities...
shorthunter
ArboristSite Guru
Finally got a picture of the cylinder bore, looks a lot like the aftermarket 7900 cylinders. I'd say there will be room to work on the transfers
