But, it's better to have problems below vs. above.
I had a problem down below once...Well..............
And itching.I had a problem down below once...
Lots of burning.
Makes sense. Ill try it out next time.Try some synthetic lotion....
I suspect that's been there since it was new. I would leave it as is.
How would that matter?I would check and see if the bottom ring is on it at bdc.
Because there's a ring end right there .How would that matter?
That's under the transfer, well away from the ring end.Because there's a ring end right there .
That's a used cylinder. If it were going to grow, I think it would have already done that, or there would at least be signs of it.How big is the void under the plating?
How thick is the plating over it?
It would be a bad spot if it grew.
Enter your email address to join: