Jonsered 2077 & 1.3 bar?

[Threadbare]

I do a small amount of milling with a Jonsered 2077 and a 18" 1.5 standard bar,
I would like the option of using a narrow bar, i.e 1.3. Can I get one for this chainsaw or would I have to modify one. Any help welcome
John.

 

[aggiewoodbutchr]

You might get better response if you asked this question in the chainsaw forum. Good luck.

 

[Jacob J.]

A 1.3m bar would work good on your 2077, what pitch chain are you using- .375" or .325"?

 

[maccall]

I do a small amount of milling with a Jonsered 2077 and a 18" 1.5 standard bar,
I would like the option of using a narrow bar, i.e 1.3. Can I get one for this chainsaw or would I have to modify one. Any help welcome
John.

I don't think so. The "Pixel" bars and chains seems only to be made with the Husqvarna small mount, and you would need the large mount. A quick check on Husqvarna and Oregon web sites gave no other information either. And if nobody in this forum knows, then it's hint in the same direction... 1.3/0.050 can of course be found, but that is not the same as them being narrow kerf. I think standard 0.325 bar and chain would be the most narrow you can find for your saw.

 

[ray benson]

Using standard 3/8 chain, the kerf will be the same for 1.3(.050) or 1.5(.058) bars and chains.