Got my dads Jonsered 621. Man what a work horse saw. I can't wait til I inherit this saw from him. Anyways, he had me clean up the saw and also look into the bar oil that would always be sitting on the ground under the saw after it sat for some time. These are my observations:
Dad hasn't cleaned out the sawdust and debris behind the clutch housing in ages. The clutch housing area was packed with oil soaked sawdust. It was obvious this oil would slowly drip down and leave a small pool on the floor. Cleaned up everything and it all seemed ok. I ran the saw and noticed bar oil shooting all over. I found the circled bolt in the attached image almost all the way out. Wondering if this bolt adjusts the bar oiler? I turned the bolt all the way in then backed it out 2 turns and the oil isn't slinging all over. Am I on the right track?
Dad hasn't cleaned out the sawdust and debris behind the clutch housing in ages. The clutch housing area was packed with oil soaked sawdust. It was obvious this oil would slowly drip down and leave a small pool on the floor. Cleaned up everything and it all seemed ok. I ran the saw and noticed bar oil shooting all over. I found the circled bolt in the attached image almost all the way out. Wondering if this bolt adjusts the bar oiler? I turned the bolt all the way in then backed it out 2 turns and the oil isn't slinging all over. Am I on the right track?