Jonsered 625 Help

[briguy26]

Hey fellas wanted to ask if anyone has any experience with a Jonsered 625 saw. My 625 seems really low on compression as if there's no resistance when I pull on it. When I did a compression check it was at 150. It starts up just fine and runs extremely well. I'm just a bit confused as to why it is so easy to pull it almost feels like it has a decompression release but I know it doesn't. Is it because it only has one ring and not two? Should I rering it or leave it alone. Thanks for any help or suggestions.

 

[bigbadbob]

Its fine @150+, IMO, I would just run it.
BBB

 

[briguy26]

Its fine @150+, IMO, I would just run it.
BBB

Its just weird to me I've never had a saw that has pulled so easily at 150psi. I want to sell it to my buddy but didn't want to sell him a potential lemon. Maybe I'll give him a good deal on it. I'm only in it for less than a Benjamin.

 

[bigbadbob]

They are a great older saw , I had one, little heavy little slow but will go forever an get the job done!! Love Oregon BTW, go to Eugene

 

[firefighterwolf]

150 psi is fine for a stock saw. Where in Oregon are you?

 

[briguy26]

They are a great older saw , I had one, little heavy little slow but will go forever an get the job done!! Love Oregon BTW, go to Eugene

Lots of real life hippies and tree huggers their

 

[briguy26]

150 psi is fine for a stock saw. Where in Oregon are you?

Living where the Golden man resides