Going to see about letting this one go. I went through this saw from the case up a couple years back and it got anything that it needed at that time, crank seals, gaskets etc.
It has been upgraded with a 930 top cover and air filter setup, it also has some custom bar studs to use regular 9mm slot big husky bars and the clutch cover has been bushed for the studs also. The wimpy 1/2" square muffler outlet got replaced with a 3/4" round tube outlet and the inner baffles modded also.
My comp tester is leaking down again but I saw it bumping 160lbs. You can see in the photo this is a thin ring piston in top shape.
Its in top shape but you can tell its been used over the years but nothing broken just a dent in the clutch cover. It is one strong running 87cc saw. I don't know what else to tell, ya, ask any questions.
I would like $350 for the PHO plus shipping. If you want a bar and chain we can talk about it.
I'm not a Jonsered collector and I could stand to lose a couple saws that are not collectable to me that are just taking up space and not being used enough.
It has been upgraded with a 930 top cover and air filter setup, it also has some custom bar studs to use regular 9mm slot big husky bars and the clutch cover has been bushed for the studs also. The wimpy 1/2" square muffler outlet got replaced with a 3/4" round tube outlet and the inner baffles modded also.
My comp tester is leaking down again but I saw it bumping 160lbs. You can see in the photo this is a thin ring piston in top shape.
Its in top shape but you can tell its been used over the years but nothing broken just a dent in the clutch cover. It is one strong running 87cc saw. I don't know what else to tell, ya, ask any questions.
I would like $350 for the PHO plus shipping. If you want a bar and chain we can talk about it.
I'm not a Jonsered collector and I could stand to lose a couple saws that are not collectable to me that are just taking up space and not being used enough.