Or just make up a new wire.
I never seen a coil on one of these. Does the wire go right into it?
If so then i would just try and seal it up.
The wire is connected to the circuitry, then the wires are held up and the board is potted to the edge of the mold. The wire just enters solid plastic. The brush on stuff is the way to go. Clean real well with isopropyl alcohol first then blow dry. Then put goo on. don't move til it drys/cures.I never seen a coil on one of these. Does the wire go right into it?
If so then i would just try and seal it up.
The wire is connected to the circuitry, then the wires are held up and the board is potted to the edge of the mold. The wire just enters solid plastic. The brush on stuff is the way to go. Clean real well with isopropyl alcohol first then blow dry. Then put goo on. don't move til it drys/cures.
this stuff works really good for cleaning up electrical connections. I have used it on points before.
View attachment 452000
where you at? askin cause of beer can.
Enter your email address to join: