Hey guys, so here I'am using my log splitter making kindling with my custom wedge. All of the sudden, the splitter dies on me. Now, it does not matter if I'm into a piece or backing out, it starts to somewhat bog down and then just dies. I hit the primer bulb and pull the chord and it fires up and runs fine for a while and then it does it again.
This has been going on all day like this. I'm finally getting irritated by this. There is something also that has been making me scratch my head. Fuel will saturate the air filter, and when the engine is not running the fuel drips out of the primer bulb. It will not stop unless the splitter is out of fuel or unless it is running.
Anyone have any ideas what the heck is going on? I was thinking that my float is screwed up. But I have not touched anything!
This has been going on all day like this. I'm finally getting irritated by this. There is something also that has been making me scratch my head. Fuel will saturate the air filter, and when the engine is not running the fuel drips out of the primer bulb. It will not stop unless the splitter is out of fuel or unless it is running.
Anyone have any ideas what the heck is going on? I was thinking that my float is screwed up. But I have not touched anything!