ThistyTurtle
ArboristSite Lurker
I'm brand new to this whole milling thing and have a quick question. I want to slab out a few lengths of oak to make some live edge benches. I have a 20" bar and bought a cheap lumber maker guide from harbor freight for doing the few cuts that I need.
The question is, can I bury the tip of the bar in the wood if my tree is thicker than my setup can cut with one pass?
Since I want a live edge on both sides, I don't want to cut a slab off each side to narrow the oak enough to fit my setup.
Thanks in advance for the advice. I hope to do some cutting this weekned.
The question is, can I bury the tip of the bar in the wood if my tree is thicker than my setup can cut with one pass?
Since I want a live edge on both sides, I don't want to cut a slab off each side to narrow the oak enough to fit my setup.
Thanks in advance for the advice. I hope to do some cutting this weekned.