Made a bucking spike for my Pioneer Farmsaw

[fossil]

I didn't look really hard but there didn't seem to be any spikes out there for a Farmsaw so I made one. It was kind of difficult to figure what to make as there doesn't seem to be any consistency to the design of these unless I am missing something.
I took an old piece of angle iron and cobbled this up.
I haven't tried it out yet. but it looks OK.

 

[Jeff Lary]

cobbled well I dont know about that but it looks very good.

 

[3000 FPS]

Looks good to me. A natural.

 

[procarbine2k1]

I think it looks good, and I bet it works just as well. Nice work...

 

[pioneerguy600]

I didn't look really hard but there didn't seem to be any spikes out there for a Farmsaw so I made one. It was kind of difficult to figure what to make as there doesn't seem to be any consistency to the design of these unless I am missing something.
I took an old piece of angle iron and cobbled this up.
I haven't tried it out yet. but it looks OK.

I did not see a post where you asked for a set of spikes but I have been out in California for a couple of weeks, you made a nice set and they will work fine. I will post a pict of one of my Farmsaws with an OEM set on it and you can see how nice yours looks compared to a factory set.

 

[DSS]

Yeah, I would have sent you one too, but your's looks good. Nice job.:msp_thumbsup:

 

[fossil]

Thanks guys.

It was slow work with a hacksaw, dremel and files, but fun. I hope I have time to give it a try on tomorrow.