Have a nice 125 for sale. Has a SP Filter cover as you can see but it’s a CP. was rebuilt 4-5 tanks ago.
New parts
O’Ring for the fuel cap and also a carb kit
Muffler
Seals
Hose springs
Clutch and drum. Recently relapped the end of crank and inside of the clutch so they mate perfectly.
Rod needle bearings and crank bearings
Intake reeds and manifold
dust cover on the recoil is a 3D printed one
slight porting on the exhaust port.
saw runs and oils like it should. I recently was running a 50” .404 full comp setup which it pulled with an 8 pin. Only selling to purchase another saw I have my eye on.
selling PHO 1100 plus the ride. If you have any questions on it let me know. Old school muscle at its finest.
New parts
O’Ring for the fuel cap and also a carb kit
Muffler
Seals
Hose springs
Clutch and drum. Recently relapped the end of crank and inside of the clutch so they mate perfectly.
Rod needle bearings and crank bearings
Intake reeds and manifold
dust cover on the recoil is a 3D printed one
slight porting on the exhaust port.
saw runs and oils like it should. I recently was running a 50” .404 full comp setup which it pulled with an 8 pin. Only selling to purchase another saw I have my eye on.
selling PHO 1100 plus the ride. If you have any questions on it let me know. Old school muscle at its finest.