McCulloch Model 99

[Big E]

My dad has a McCulloch Model 99 powerhead with auger atachment and a 6' two man chainsaw attachment. I would like to get it running but the carb has a small gas leak at one of the gaskets. It has not run in about 20 years. We put premix in it and pulled the starter a couple of times after cleaning the air filter and installing a fresh plug and disassembling, cleaning and reassembling the carb. The Diaphragm looks O/K but the gaskets are tired but intact. It coughed a couple of times then flooded. Does anyone have information about this powerhead and would anyone have any NOS parts for something 50 to 60 years old. Thanks Big E

 

[superman_36]

this is a site that will give you a little info on the saw i will look to see if i have a IPL for that saw and i could get the part number for you

http://www.acresinternet.com/cscc.nsf?OpenDatabase

 

[superman_36]

carb gasket to intake #18036B

carb body gasket #18200B

Entire carb # 18214G

You will have good time trying to find them you should just make them your self with an exacto knife

 

[Big E]

Thanks for the quick reply! I most likely will make them i just thought someone might still use these old dogs somewhere.

 

[Bill G]

I have a few of the saws here. At the back of the line are (3) 99's and a auger attachment.

Bill

 

[Big E]

Any idea where to start looking for any parts? Thanks!

 

[GOBRDGO]

Ask Bob, He's the man Bob Cornwell, [email protected]