Carburetorless
ArboristSite Guru
I bought a used MS 192TC.
The saw was hard to start at first, so I cleaned the carb, then I adjusted the H, L, and LA screws. Now it starts and idles(sometimes idles fast at first then smooths out), but when I pull the trigger the saw bogs down and dies.
The only thing I noticed that seems odd about the saw(other than the way it runs) is the primer bulb, it doesn't want to pop back out when I press it in, it sticks for a while then eventually pops back out.
I want to put a new carburetor on it, but I can't find one online anywhere(going to see a dealer tomorrow).
I'm convinced it's a carb problem, but I could be wrong.
I'm hoping that someone here can diagnose the problem better than I can. Do you think it's the carb, or is it something else?
Thanks
The saw was hard to start at first, so I cleaned the carb, then I adjusted the H, L, and LA screws. Now it starts and idles(sometimes idles fast at first then smooths out), but when I pull the trigger the saw bogs down and dies.
The only thing I noticed that seems odd about the saw(other than the way it runs) is the primer bulb, it doesn't want to pop back out when I press it in, it sticks for a while then eventually pops back out.
I want to put a new carburetor on it, but I can't find one online anywhere(going to see a dealer tomorrow).
I'm convinced it's a carb problem, but I could be wrong.
I'm hoping that someone here can diagnose the problem better than I can. Do you think it's the carb, or is it something else?
Thanks