West Texas
ArboristSite Guru
Recieved my 'woods' modified 361 back today. Put on a .325 square chisel chain with a 9T drive sprocket and 16" bar. Made a minor H jet adjustment for my higher elevation. Took it to the woods and made 26 cuts on a downed dead oak about 9+ inches in diameter. Average time was about 5 sec, using the "one thousand one" and "one thousand two" concept as I was by myself and did not have a timer or video camera.
I pushed the saw down into the wood very hard in an attempt to bog it down; but, it just kept cutting. That was impressive, especially on a 9T drive sprocket set up.
Will be out of town tomorrow; but, plan to take a helper to time and video it on Thursday. Will post results then. Tom
I pushed the saw down into the wood very hard in an attempt to bog it down; but, it just kept cutting. That was impressive, especially on a 9T drive sprocket set up.
Will be out of town tomorrow; but, plan to take a helper to time and video it on Thursday. Will post results then. Tom