Hi
My MS440 started last fall to chock when I was using it. In a middle of a cut at high speed the engine just stop right away. If I'm fast enough I can release the accelerator an be able avoiding the engine stop. During winter as dismantle the saw and change cylinder and piston. Everything was ready for a good maintenance. At the same time I also changed gas filter and check on/off switch. After all this work I run the saw. I start well but it seems I have exactly the same issue.
If I run the saw mid speed (half trigger down) I can run the saw without problem, but when I push the saw at the maximum, immediately it dies. Again if I'm fast enough, I can avoid it dies by releasing the trigger. Is someone have any Idea about this issue.
Thank you
My MS440 started last fall to chock when I was using it. In a middle of a cut at high speed the engine just stop right away. If I'm fast enough I can release the accelerator an be able avoiding the engine stop. During winter as dismantle the saw and change cylinder and piston. Everything was ready for a good maintenance. At the same time I also changed gas filter and check on/off switch. After all this work I run the saw. I start well but it seems I have exactly the same issue.
If I run the saw mid speed (half trigger down) I can run the saw without problem, but when I push the saw at the maximum, immediately it dies. Again if I'm fast enough, I can avoid it dies by releasing the trigger. Is someone have any Idea about this issue.
Thank you