chevyforlife21
ArboristSite Guru
I realize I'm in the chainsaw forum but trying to get some good answers new husky 323L which is supposed to be the start of the pro series as I understand it. my husky 125 blower had a similar rattle it's life after 2 years I sold it as I felt the bearings were gone with the knocking.
New trimmer doing my typical heat cycle of 3 times let idle mostly then cool did that used 1/4 tank of gas filled with vp small engine 50:1 which always seems to run real rich in everything I noticed when ever I blip the throttle I hear a rattle I'm not sure if it's the clutch or bearings Piston slap not sure it was slightly lean on the low jet after I did all this, motor cover seems to be real hot compared to my echo I was just running any idea? Is it just dry in there from being new or do clutch springs have to brake in or something?
Sent from my SAMSUNG-SM-G935A using Tapatalk
New trimmer doing my typical heat cycle of 3 times let idle mostly then cool did that used 1/4 tank of gas filled with vp small engine 50:1 which always seems to run real rich in everything I noticed when ever I blip the throttle I hear a rattle I'm not sure if it's the clutch or bearings Piston slap not sure it was slightly lean on the low jet after I did all this, motor cover seems to be real hot compared to my echo I was just running any idea? Is it just dry in there from being new or do clutch springs have to brake in or something?
Sent from my SAMSUNG-SM-G935A using Tapatalk