Trigger-Time
Addicted to ArboristSite
Hello, I’m new to the site. Have been reading this site for a little
wile and thought it was time to join in. So here it goes. I have
some eastern red cedar that I’m thinking about milling with
my chain saw. It is a 036 that I bought new it has had less 20
tanks of gas run through it. Is this saw big enough for 10 to 16 in.
Dia. cedar? With out being overly hard on the saw. Any suggestions
On what brand of mill to buy and cheapest place to buy. Any and all
Information will be greatly appreciated.
Thanks, Gary
wile and thought it was time to join in. So here it goes. I have
some eastern red cedar that I’m thinking about milling with
my chain saw. It is a 036 that I bought new it has had less 20
tanks of gas run through it. Is this saw big enough for 10 to 16 in.
Dia. cedar? With out being overly hard on the saw. Any suggestions
On what brand of mill to buy and cheapest place to buy. Any and all
Information will be greatly appreciated.
Thanks, Gary