Fired up one of my 4000 tonight ,just wanted to hear it run and it sounded good
Nik's Poulan Thread
- Thread starter FATGUY
- Start date
Help Support Arborist Forum:
Nice you up to cutting yet? How's the thumb?
[emoji106]
Steve
Steve
Old thumb is doing just fine other than no nail I'm back to doing anything I want, don't even notice that I don't have a nail till I try and pick something thin up. 
Glue one on, trim to fit.
Steve
Steve
Hahahaha good 1 and replace it as it wears out. Good Todd very good I still think you were lucky
My latest project that I made from a old pallet, little shelf unit to go in the bathroom 
That's because you have some nice wood to cut. Lots of work but also some fun along the way. Good job on cutting, was that from your place
A mile down the road, tree job, two different trees
Sent from my iPhone using Tapatalk
Is that a 20 bar or 24 inch.
20” with no spike, I need to upgrade saws to a bigger one for the rest of the tree, going to use 7700 4900 5400 this time
Sent from my iPhone using Tapatalk
Wow, I'm going to jump all over that high priced stuff, not. I thought some of the other parts were getting out of hand but those take the cake
Should list my crankshaft for 300, it's new and would fit right in
But they are professional parts and super rare and new bearings, and need kits, some assembly required. You'd have a $2000.00 saw, minus p/c and a few other parts.
Steve
Steve
You need that much luck to keep from peein' on the floor? LOL
I don't care who you are that's funny
Bobby Kirbos
Scrounger of Cellulose Based BTUs
I do, but it's not about directional control. The real problem is making sure the delivery nozzle is properly supported. That shelf looks to be the perfect height, but the hole may be a touch on the small side.
Similar threads
