Was seriously tempted on that one. No extra jingle right now to purchase saws.
Nik's Poulan Thread
- Thread starter FATGUY
- Start date
Help Support Arborist Forum:
Was seriously tempted on that one. No extra jingle right now to purchase saws.
Nice looking saw, pure envy for whom bought it.
Steve, Samsung On5 using Tapatalk
Steve, Samsung On5 using Tapatalk
I see if has the hot air block off plate for winter use.
Steve, Samsung On5 using Tapatalk
Steve, Samsung On5 using Tapatalk
Got to pull the cylinder off my acquired S25da, do I need to pull top half with fuel tank or what, manuel I have doesn't state pulling cylinder or fuel tank. I see some scoring on piston and need to pull it down to see what's going on, hopefully cylinder is ok. Might be able to polish out piston.
Steve, Samsung On5 using Tapatalk
Steve, Samsung On5 using Tapatalk
Had to clear a spot for it.
I just acquired a Poulan 25 with the auto sharpening system and it appears to be complete. I usually just take it off and use a conventional chain but just got kinda curious about how well it works. Since I've never used one of these exactly how do you use it correctly? Mine has a little black knob on top with an arrow on it, I assume you run it then turn the knob per the arrow?
I would say yes, but I have been wrong at times.
Steve, Samsung On5 using Tapatalk
Steve, Samsung On5 using Tapatalk
Wonder if you can use that power sharp system chain oregon has with the old power sharp?
Steve, Samsung On5 using Tapatalk
Steve, Samsung On5 using Tapatalk
stubnail67
Addicted to ArboristSite
pretty sure you push it forward and the stone pushes down i will have to look on the inside of the clutch next time i have it apart
Still has the correct chain install for it to work?
Steve, Samsung On5 using Tapatalk
Steve, Samsung On5 using Tapatalk
turn knob adjusts for chain/stone wear? had one once, seemed like that's how it worked. ran "normal" chain while I had it.
put the ps back on for new buyer.
put the ps back on for new buyer.
stubnail67
Addicted to ArboristSite
yea has to have the power sharp chain to work the old kind
Acornhill - just curious why the newer PS chain would not work in the older system, seems they both just touch off the top of the tooth what makes the two incompatible? From what I know about the new set up, the chain has a carbide tooth to dress the stone and keep it in trim but I don't see why that would not work with the older stones as well.
Thanks,
Mark
Thanks,
Mark
I haven't seen a manual for the 25 but here's one with powersharp op instructions on page 12 for a 3700
Found one for the micro as well. Page 12
Think I'll be able to clean the cylinder with a little acid and maybe polish the piston, or replace piston?
Steve, Samsung On5 using Tapatalk
Steve, Samsung On5 using Tapatalk
Better picture of the first one.
Steve, Samsung On5 using Tapatalk
Steve, Samsung On5 using Tapatalk
20 micron lapping paper for the piston clean up. I'd be afraid to get acid anywhere near that cylinder, tho! May try goin' real easy with red Scotch-brite and see where that gets you and then go a little more aggressive if there's any noticeable progress. Looks mighty nasty.
Had a far bit of transfer, just glad it's a chrome bore.
Steve, Samsung On5 using Tapatalk
Steve, Samsung On5 using Tapatalk
