hamlet_jones
ArboristSite Lurker
I enjoy this saw, even if it's a dinosaur. I just finished cutting up a big alder, and it seemed the bar was
kinda dry. I topped off the bar oil before I started, and afterwards I looked in the reservoir, and still
saw about 2/3 of a tank. Gas is almost out. I found the adjustment, turned it to the +, but still not
too much spitting out. Maybe my oil pump is going? I just cleaned the oil passages in the bar, so
anything else I can try?
kinda dry. I topped off the bar oil before I started, and afterwards I looked in the reservoir, and still
saw about 2/3 of a tank. Gas is almost out. I found the adjustment, turned it to the +, but still not
too much spitting out. Maybe my oil pump is going? I just cleaned the oil passages in the bar, so
anything else I can try?