SierraMtns
ArboristSite Operative
Ok guys I am seeking some guidance on porting my 365 XT. This is my first time porting a saw. Here is what I have done so far.
So far I have blended the intake to favor the lower intake. Re-shaped the upper x-torq ports so the air doesn't crash into a flat wall. And worked on the lower transfers.
Next I want work on the exhaust and this is where I am stuck. I am planing on widening the exhaust port.
Do I widened it from the cylinder to the muffler?
How do I widened it evenly on both sides of the exhaust port? I can't figure out a way to mark it inside the cylinder so I am grinding both sides of the exhaust port evenly.
Thanks
So far I have blended the intake to favor the lower intake. Re-shaped the upper x-torq ports so the air doesn't crash into a flat wall. And worked on the lower transfers.
Next I want work on the exhaust and this is where I am stuck. I am planing on widening the exhaust port.
Do I widened it from the cylinder to the muffler?
How do I widened it evenly on both sides of the exhaust port? I can't figure out a way to mark it inside the cylinder so I am grinding both sides of the exhaust port evenly.
Thanks