Well I have got my 372 ported{I think} for Terry's GTG. Now I am going to try my hand again at grinding.
My questions for this saw are Should I make the windows in the piston bigger than they are now or would it not benefit from that? Also should I change the timing at all or just go for the bigger ports? It seems to have quite a bit of room to widen and clean up the intake and exhaust ports from what I have measured so far.
Any help from you guys is always appreciated!
My questions for this saw are Should I make the windows in the piston bigger than they are now or would it not benefit from that? Also should I change the timing at all or just go for the bigger ports? It seems to have quite a bit of room to widen and clean up the intake and exhaust ports from what I have measured so far.
Any help from you guys is always appreciated!