CsClimbr
Ex-Climber with CAD
short story.. built another 044 from pieces. Split case, bearings/seals the whole 9. I removed the base gasket after seemingly not getting any type of reading on squish using solder. Now with no gasket it’s still reading a little much on squish .030~ give or take BUT a compression test is showing 175+ psi and damn near pulling my shoulder out to turn her over. Is this anywhere near normal? It’s a slantfin with no decomp (maybe I should have used the 440 decomp jug I had)
My arm appreciates any help
My arm appreciates any help