I have a 435 which is for the little stuff, a Dolkita 6421 for bigger stuff. I'm getting into chainsaw milling and of course, want more power... I'd like to butcher a sprocket nose to take my 435 so I can run both saws, this is going to be way cheaper than one big saw. My main issue is the lack of choice of sprocket size for the 435. It's 7 tooth 325 only. I can't find a rim clutch for it, but suspect there's something out there that would fit, much like the echo drum I put on a dolmar. So, anyone know of a rim clutch for a 12mm crankshaft, 63mm id, 66mm od? I can lock the oiler to the crank if the clutch doesn't have the drive dogs. I'd give a few bucks for a worn out Oregon powermatch nose so I don't need to sacrifice a new one.
Sent from my XT830C using Tapatalk
Sent from my XT830C using Tapatalk