SawTroll
Information Collector
He really likes Gary Goo at 50:1....
Actually I prefer Aspen (or similar) alkylate fuel, premixed 50:1 with synthetic oil.
He really likes Gary Goo at 50:1....
I was wondering about him also.Good fella even if he doesn’t like Dolmar’s.
Or Echo's
Sorry to say so - but as I recall it, that one belongs to a model "family" that sort of was a "low point" in the Jonsered(s) story - and represent Jonsereds attempt to design lighter and less costly saws than (most of) their 1970s saws themselves. This lead to rebranded Partner saws being sold as their smaller "pro" saws for a while, starting with the 490.Hello Niko what can you tell me about the jonsered 450 i just got one it is from the 80's i think?
One of the sawtroll classics: A younger guy was in here a couple years back asking what it felt like to operate older saws that were heavier with less effective A/V. ST pipes in and says "if you want to see what it felt like to run a saw from the early 80's, just find a new Echo!" Zing!!
With 66.443 husky sponsored posts, he's now officially known as the "the scandinavian pope' But we all like him of course. We had a lot of fun on this site a few years back, that's for sure.
Now he must be in his winter sleep in his cabin near the arctic with almost 24 h darkness.
@SawTroll, I picked up a Husqvarna 480CD. Do they have the same ignition as the 2100?
Have you cut with a 480 before?
Actually I prefer Aspen (or similar) alkylate fuel, premixed 50:1 with synthetic oil.
They want to start selling Aspen over here.
Troll, my Dolmar/Makita 520i ran so well yesterday that I have elected to keep it. I bucked a whole truckload of rounds with one tank of fuel. The guy that I was cutting with milled about a dozen 9' logs, each 8/4 thick and 28" wide by using a Dolmar/Makita 6421 and a milling jig that worked flawlessly. He pilled a 32" bar. Perhaps you need to examine and evaluate Dolmar/Makita chain saws again.
I bought a brand new one and used it for about 3 years for firewood and cutting contest back in the day@SawTroll, I picked up a Husqvarna 480CD. Do they have the same ignition as the 2100?
Have you cut with a 480 before?
I have been looking for a nice 180/280/380/480 for a while. They always show up when I am tied up with something else lol.
Enter your email address to join: