Boon
Addicted to ArboristSite
Am wanting to bolt the bar directly to the mill eliminating the calmps but am unable to find picture/descriptions on exactly 'how to' some pics are not there.
I was thinking of two ways:
1. Cut off the height adjustment/measure square hollow section (SHS), drill through the top clamp plate and weld a bolt on the inside of the cut off SHS & re-weld (tig)
2. Only drill through the top clamping plate into the measuring SHS and drop an elongated nut down into it...only thing the nut can do is move up and down but not spin if it is the correct size.
cut and shut on the mill is not appealing due to possible breakage or fracturing onsite, sometimes modifying something can lead to other problems which I am trying to avoid.
I was thinking of two ways:
1. Cut off the height adjustment/measure square hollow section (SHS), drill through the top clamp plate and weld a bolt on the inside of the cut off SHS & re-weld (tig)
2. Only drill through the top clamping plate into the measuring SHS and drop an elongated nut down into it...only thing the nut can do is move up and down but not spin if it is the correct size.
cut and shut on the mill is not appealing due to possible breakage or fracturing onsite, sometimes modifying something can lead to other problems which I am trying to avoid.