Say you are doing a removal with a crane. All the brush is off and you are left with the spar. After setting the chokers at the top of the spar you come down to cut a log length piece of wood (8-20 feet). What is the best way to set your climbing line and safety line around a large diameter spar in order to make the cut? I will take the snap while attached to my climbing line and whip it back and forth (clockwise and then counterclockwise) at about eye level trying to lengthen it with each whip until it goes far enough around the spar where I can grab the snap and then tie in. Not sure if this explanation makes sense. Just wanted to see if there is an easier or better way to do this. Did a large poplar removal today and thought there has got to be an easier way. Thanks