ChainsawmanDan
ArboristSite Member
I need piston rings for Shindaiwa 695 part number 22150-41210. I have the piston just need the rings. Thanks
You can become a Supporting Member which comes with a decal or just click here to donate.
Ok That would be great. I pulled one off this morning so I will measure it when I get home later tonight. I’m at work right nowIf you can tell me the thickness of the old ones I should be able to direct you to a set of Cabers that will work.
Thickness of the rings are 1.50 mmOk That would be great. I pulled one off this morning so I will measure it when I get home later tonight. I’m at work right now
Ok I will try to call some places tomorrow. Thank youThe 695 rings are narrower than the Stihls although thickness is correct @1.5mm. They are also etched with a T for top just like your old one as shown. You can still order new rings from most parts houses and Shindaiwa dealers. About $10 a piece. Hope this helps.
Yeah I was thinking NOS is the only way I can find them. I know caber at one time made them as well but I think they are obsolete now.It could be that the Shindaiwa rings are just severely worn, but idk. I was thinking a Stihl/Husky ring of the same o.d. might work, but it’s looking like I may be wrong. If the 390 ring is the same diameter, maybe try that on the Shinny piston and see if it will fit in the cylinder. If it won’t, I‘m guessing you’ll just have to wait for n.o.s. ones to pop up on eBay.
EbayHey Dan where did you get the piston from?I ordered piston and barrel from my local dealer and it has 580 on the barrel and is about 3mm smaller. When i look up the part number it says its for the 695 and a few models under it like a 570 etc
cost me a few hundred dollars too ><
The 695 had 2 different pistons I believe. One with a 11 mm wrist pin and one with 12 mm. Both 49 mm.Ebay
Enter your email address to join: