lambs
Stihl crazy after all these years
Is that all you do, b1tch? Let someone like something with out you b1tching all about it. Do you have a life?
All of us have a right to our own opinion, and I think SawTroll clearly acknowledged that.
Is that all you do, b1tch? Let someone like something with out you b1tching all about it. Do you have a life?
All of us have a right to our own opinion, and I think SawTroll clearly acknowledged that.
I've been curious about this myself. Been thinking of running a 20" .404 setup on my 660 for bucking Hedge/Oak/Locust... Especially if would hold a hedge longer or if it was in the least, less susceptible to chain stretch...
My 750 that you tried out at the last GTG had a full comp .404" Stihl full chisel on a 36" bar. It seems to work OK with that saw huh?:msp_rolleyes:
I've got an XP 1020 with a Stihl 1/2" semi chisel on a bar a little over 20" long. You get to experience the true definition of non anti-vibe after making/surviving a cut with it. It pulls some chunks of wood out of the cut and you can feel every one of them as it does it.:msp_scared:
Ok so dumb question: Can I roll a .404 on my 0.63-3/8" bar, or do I need a new bar/drive sprocket just to test this theory?
You need a .404 tip (unless it's a hard nose bar) and a .404 drive sprocket/rim and make sure the gauge is the same.
Is that all you do, b1tch? Let someone like something with out you b1tching all about it. Do you have a life?
This thread by TK got me wanting to try .404
http://www.arboristsite.com/chainsaw/189188.htm
Many will say it does not make since and at this point I can’t disagree. But I’ve noted MCW (Matt) is a fan of .404 due to its good wear characteristics and he cuts lots of wood and knows his chains. May be a good set-up for the dirty wood I’ve been cutting. Less time filing, more time cutting.
First, I sourced some .058 gauge .404 semi-chisel Carlton chain. Then just added a .404 Oregon style tip to an 18” .058 bar using a .404-7 rim. I like to run short bars and the short length may help off-set the heavier chain.
i think you will be happy with it i went out today and tested 4 chains and 7&8 pin sprockets and it was close go the 404
I know I've been away from the site for a while, so maybe I missed something along the way, but what is with this sudden resurgence of raggin' on ST? I've seen it in a handful of posts lately, and it is tasteless.
Don't like what ST has to say? Then ignore it. A man is entitled to his opinions about saws and chains and cutting technique, and he's entitled to voice them if he wishes. There's nothing wrong with that.
But to go insulting people over the internet, as you did above, that's pretty pathetic. If I were you I would refrain from doing that again in the future. It isn't very becoming.
Enter your email address to join: