Hi folks I am new to this site. Can anyone help with suggestions. I have a chain modified to the Granberg tooth pattern ( you will know how it has slicer and clearer teeth ground different shapes ). Well it certainly gives a smooth cut but the Stihl 075 (110 cc ) I drive it with loads down easily in some of our timbers. The bar is only one metre long ( 40") cutting through logs no more than 600 mm (24").
I have the idea that maybe I can remove some of the teeth, say leave the one slicer immediately in front of the next clearer, then remove the next clearer, leave the next slicer, leave the next, remove the next clearer, leave the next slicer, remove the next clearer, and so on for the entire length of the loop of saw chain. Would this work.
I have the idea that maybe I can remove some of the teeth, say leave the one slicer immediately in front of the next clearer, then remove the next clearer, leave the next slicer, leave the next, remove the next clearer, leave the next slicer, remove the next clearer, and so on for the entire length of the loop of saw chain. Would this work.